ASTM A – Designation: A /A M – 02a Standard Speci?cation for Steel Sheet, Aluminum-. Find the most up-to-date version of ASTM A at Engineering ASTM A/AM: Standard Specification for Steel Sheet, Aluminum-Coated, by the Hot-Dip Process.

Author: Yozshukora Kigajora
Country: Philippines
Language: English (Spanish)
Genre: Finance
Published (Last): 18 June 2018
Pages: 47
PDF File Size: 15.99 Mb
ePub File Size: 20.63 Mb
ISBN: 808-2-70591-953-7
Downloads: 37125
Price: Free* [*Free Regsitration Required]
Uploader: Tygojinn

ASTM A463 Grade FSS-439

The relationship between the standards adtm only be approximate; therefore, the respective documents should be consulted for actual requirements. Those who use these documents must determine which speci?

To see MatWeb’s complete data sheet for this material including material property data, metal compositions, material suppliers, etcplease click the button below. The purchaser shall specify the appropriate table of thickness tolerances in Speci?

The new designations are de?

It is intended principally for heatresisting applications and also for uses where corrosion resistance and heat are involved. For all designations the coating bend test inside diameter shall be equal to twice the thickness of the specimen. Property Data This page displays only the text of a material data sheet.

Satm greater number of digits are shown in Table X2.

If you feel that your comments have not received a fair hearing you should make your views known to the ASTM Committee on Standards, at the address shown below. B These typical mechanical properties apply to the full range of steel sheet thicknesses. We also ask that you refer to MatWeb’s terms of use regarding this information.

  KONDITORSKI PROIZVODI PDF

Some of the reasons for axtm limited relationship are the following: Flaking of the coating within 0. E For carbon levels less than or equal to 0.

C these ranges are to be expected. If the hardness result is 85 HRB or higher, no tension test is required. These mechanical property values are nonmandatory. This standard has been approved for use by agencies of the Satm of Defense. We appreciate your input. J Shall contain silicon 1.

When the amount of vanadium, titanium, or columbium is less than 0. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Titanium is permitted for SS steels to 0. Because of the many variables and changing conditions that are characteristic of continuous hot-dip coating lines, the weight [mass] of coating is not always evenly divided between the two surfaces of a sheet, nor is the coating evenly distributed from edge to edge.

They asym intended solely to provide the purchaser with as much information as possible to make an informed decision on the steel to be speci?

This abstract is a brief summary of the referenced standard.

  BOBINAGE ALTERNATEUR PDF

A user with concerns about the appropriate coated steel to order for a speci? Each system shall be used independently of the other. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. B No minimum means that there are no established minimum requirements for triple- and single-spot tests, but aluminum coating shall be present.

The purchaser may negotiate with the supplier if a speci? Values in inch-pound and SI units are not necessarily equivalent. This is not considered to be a fault astj the steel but is rather a function of the induced cold-work.

ASTM A Aluminum-Coated Steel, Type I, Drawing Quality

Users requiring more precise data for scientific or engineering calculations can click on the property value to see the original value as well as raw conversions to equivalent units. Originally aatm as A — 62 T.

The yield strength tends to increase and some of the formability values tend to decrease as the sheet thickness decreases. We advise that you only use the original value or one of its raw conversions in your calculations to minimize rounding error.

Please contact us at webmaster matweb.