Akai S Sampler & MD disk drive owners manuals. I no longer have this sampler/drive, but I found the owners manuals in my file cabinet. This is. AKAI MODEL S SECTION 4 SCHEMATIC DIAGRAM AIVIC PC BOARDS No part of this manual may be re- produced in any form without permission from. Akai S This page is mainly under construction. 😉 I want to collect here useful information regarding the Akai S Sampler. user manual (to be scanned); service manual part 1 · service manual part 2 · Update: Info regarding the.
|Published (Last):||27 December 2014|
|PDF File Size:||5.37 Mb|
|ePub File Size:||17.72 Mb|
|Price:||Free* [*Free Regsitration Required]|
With this disoldering tool HAK. If any of this information is omitted, there are instances in which parts cannot be shipped or the wrong parts will be delivered. This can be accomplished by using the Reference Number listed at the right of the part number in the Parts Index.
Pull up on the felt pad holder, then remove the felt pad from the holder. A splicing point can be selected at any time by switching to the manual splice mode.
Akai S612 Manuals
Some of its features included bit sampling from 4 to 32kHz with loop and truncate e612, an overdub function and mic or line input jacks. Check that replaced wires do not contact sharp edged or pointed parts. Replace only with parts number specified. Hold your finger on the felt pad holder to keep it open until you have attached the new felt pad.
Accordingly, replace the mecha block refering to the mecha block replacement meth- od page Use specified internal wiring. Then confirm the operation.
Board into an old type unit, be sure to modify Power Supply P. Reattach the upper cover to the Akai MD with the 6 screws 1 screw each for the front and the rear panels, 2 screws each for the left and right sides of the upper cover. Sound distorts when sampled at maximum level. It’s definitely a limited sampler, but it makes a cheap back-up instrument that may come in handy for lo-fi sounds or triggered effects.
When transporting the Akai MD over a long dis- tance, be sure to insert this protection card inside of the disk holder again. Never connect this plug to any other equipment. I asked him, whether he would still sell it, but he mnual “Oohm, I could build it, but I don’t like the hustle with sending gear, checking bank accounts and similar stuff; people will call me and stuff like that; but if you [means me] are really interested, you could take over manula distributor part”.
When placing an order for parts, be sure to list the parts no. An optional disk drive that features the quick disk QD 2. Never touch the magnetic sheet, as dust and scratches may cause data error.
Full text of “Akai S Service Manual Part 1”
The determination can be performed by replacing the felt pad with a new one. To improve reliability No.
Thanks, Caleb Read more It features a continuous variable low-pass filter and an LFO for modulating and giving your sample an animated edge. Because the starting or ending point of the sample can be selected at any time, it is possible to play the sound after elimination of an undesired portion of the sample. Never con- nect any other equipment to the MD28Q. Confirm the wearing condition by the following procedure: When he went over to Akai, this became the S IC 1 VEE -8,9 2 2.
August 25, Printed No. Board has been changed as follows. The Recommended Spare Parts List shows those parts in the Parts List which are considered particularly important for service.
Refer to Replacement Method of Each Block on page Refer to the head cleaning method as shown in the Maintenance I page 12 and perform the cleaning. To improve performance In order to prevent noise or distortion in sound when a chord is played, the registor value in Main P. Parts identified by the A symbol parts are critical for safety. The determination is performed by using the S and the test media for operation.