This standard is issued under the fixed designation D ; the number immediately 1 This test method is under the jurisdiction of ASTM Committee D20 on. ASTM D is a testing standard designed to measure the friction of plastic film and sheeting. The ASTM D standard test method is used to determine the kinetic (moving) and static (starting) resistance of one surface being dragged.
|Published (Last):||9 December 2016|
|PDF File Size:||7.33 Mb|
|ePub File Size:||19.80 Mb|
|Price:||Free* [*Free Regsitration Required]|
The test is used to determine the kinetic moving and static starting resistance of wstm surface being dragged across another. Bluehill LE for Basic Testing.
Send us a request Wilton UK: Glossary of Materials Testing Terms. For a specific precautionary statement, see the end of 6.
The static coefficient of friction is equal to the initial force scale reading divided astmm the sled weight. The force to get the sled started static and to awtm motion kinetic is measured. Inspection Validating the specifications, value and safety of your raw materials, products and assets. The challenges of testing to this standard are: It is important to review ASTM D in order to fully understand the test setup, procedure, and results requirements.
Coefficient of Friction ASTM D
Both procedures yield atsm same coefficients of friction values for a given sample. Evaluating how your products and services meet and exceed quality, safety, sustainability and performance standards.
Standards can be obtained from appropriate standards authorities. Assurance Testing Inspection Certification.
Instron ASTM D Coefficient of Friction of Plastic Film – Instron
Users of previous versions of software such as Bluehill 2 and Bluehill 3 can easily upgrade to the newest version of Bluehill. Need help or have a question? Subscribe to Instron News!
For this reason, it is sometimes meaningless to compare slip and friction properties of films or sheets produced at different times, unless it is desired to study this effect. Bluehill Universal Brochure Bluehill Universal Software is built from the ground-up for touch interaction and an intuitive user experience. These additives have varying degrees of compatibility with the film matrix.
It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. The blooming action of many slip additives is time-dependent. All measurements are in grams. Some of them bloom, or wstm to the surface, lubricating it and making it more asgm. A specimen is attached to a sled of specified weight.
Link to Active This link will always route to the current Active version of the standard. Correlation of test results with actual performance can usually be established. Check this box to receive pertinent commercial email from Instron focusing on products, upcoming events, and more! Assurance Enabling you to identify and mitigate the intrinsic risk in your operations, supply chains and business processes.
ASTM D1894-14 Coefficient of Friction of Plastic Film
These methods yield empirical d184 for control purposes in film production. Due to copyright restrictions, we are not able to provide copies of standards. The film under test is secured on a flat surface and a sled of known weight is wrapped in the same material. Low force measurement Data rate used to capture peaks and troughs Reporting calculations in compliance with the standard Instron’s Solution: ASTM D is a test method to determine static and kinetic coefficients of friction of plastic film and sheeting.
The kinetic coefficient of friction is equal to the average force reading obtained during uniform sliding of the surfaces divided by the sled weight.
Onsite Training At Your Facility. Because this blooming action may not always be uniform on all areas of the film surface, values from these tests may be limited in reproducibility. Formally confirming that your products and services meet all trusted external and internal standards.
Therefore, it is advisable to refer to that material specification before using this test method. Testing Evaluating how your products and services meet and exceed quality, safety, sustainability and performance standards.