STMicroelectronics MW Series EEPROM are available at Mouser Electronics. Mouser offers inventory, pricing, & datasheets for STMicroelectronics . Errors and solutions here for eeprom read/write with Carprog programmer: Error 1: “ID not found” when read eeprom EEPROM, Serial SPI, 16 Kbit, 2K x 8bit, 10 MHz, SOIC, 8 Pins The M WMN6P is a 16Kbit (2K x 8bit) serial SPI bus EEPROM (Electrically Erasable.

Author: Zulusho Meztisida
Country: Kazakhstan
Language: English (Spanish)
Genre: Technology
Published (Last): 21 March 2004
Pages: 477
PDF File Size: 19.62 Mb
ePub File Size: 14.68 Mb
ISBN: 578-6-72493-971-2
Downloads: 81988
Price: Free* [*Free Regsitration Required]
Uploader: Milmaran

Device blank check failed at address: What is your another adapter part number?

So, if you can not read anything out, make sure your pins have good contacting. All other pins are pin to pin connect to programmer socket. Reply 7 ZLM Posts. That is safe and fastest way. Which part number you selected in software? Chip is blank does this 95106 this chip is empty???

Carprog reads/writes eeprom with A4/A6 adapter | OBDIIcom Official Blog

Reply 3 ZLM Posts. To be honest though, the other adapter i bought, not sure what its for?? Reply 11 benaknoun Spain Posts. Hi, it seems i’m doing something right then!

  LEGO 6675 INSTRUCTIONS PDF

Reply 13 benaknoun Spain Posts. It is SOIC8 mil chip. Reply 18 benaknoun Spain Posts. Reply 16 benaknoun Spain Posts. Reply 9 ZLM Posts. Reply 10 benaknoun Spain Posts.

Carprog 9.31 reads/writes eeprom 95160 with A4/A6 adapter

You can save data as. Reply 19 ZLM Posts.

Reply 14 benaknoun Spain Eepromm. Hi, thanks for your reply, here are the numbers on the chip: Hi, i have received the tools i bought from mcumall canada, there are numbers on the adapters, how do i know which pin is the right matching one with the chip? Reply 5 ZLM Posts.

But the fast way is to remove it from board and program it on the programmer ZIF spcket directly. If the chip is not designed for programming in circuit, then you need to try to find some connection. eeeprom

Reply 15 ZLM Posts. Reply 12 ZLM Posts. Reply 6 benaknoun Spain Posts. Reply 8 benaknoun Spain Posts.

MCUmall EPROM BIOS Chip Burner Forum – 8pin

The only way to test data is: Once the chip is blank, then you can load your data file and click on Write button to wrtie the data into chip. Reply 17 ZLM Posts. When you uploading the image, only use letter and number as file name.

  IBERT PIECE FOR SOLO FLUTE PDF

The “Device blank check failed ” means the chip is not a blank chip, there are some data in the chip. Also, another question please about the same chip: Hi, i have connected the tool to the chip and adapter to the programmer. The wire can be any wires, as long as you can solder it.

Reply 2 benaknoun Spain Posts. That is depending on your circuit design. Hi, ok forget this chip, its damaged Also, when i click on ID, it says “function not supported esprom this device” Image Insert: What is your chip on board?

Reply 4 benaknoun Spain Posts. Try to power up the board and do not connect pin 8 Vcc pin. Most of used on-board chips should have something.