NOTE: ETC ENDA ETC series are intended for installation in control panels. Make sure that the device is used only for intended purpose. The shielding. Thank you for choosing ENDA EPC profile controller. * Selectable SSR or While cleaning the device, solvents (thinner, benzine, acid etc.) or corrosive. Double set point. Selectable sensor type (Pt, J, K, L, T, S, R). PID control function with accurate self-tuning. Digital inputs can be assigned to 3 different.

Author: Grogis Mezit
Country: Seychelles
Language: English (Spanish)
Genre: Health and Food
Published (Last): 27 June 2007
Pages: 455
PDF File Size: 6.71 Mb
ePub File Size: 11.67 Mb
ISBN: 278-9-66333-221-2
Downloads: 70255
Price: Free* [*Free Regsitration Required]
Uploader: Dujora

If any key is pressed while P. If independent alarm is selected, A1.

Enda ETC Series PID Temperature Controllers Panel Mount | Rapid Online

So the set point can be achieved by minimum fluctuations and in the shortest time. Selectable logic control output. During an installation, all of the cables that are connected to the device must be free of energy. The maximum value is the value of A2.

Enda ETC Series PID Temperature Controllers Panel Mount

After 1 second following dtc release of the key, initial condition is returned. The maximum of C. Process value during normal operation Mnemonic parameter code during programming SV Display: Use suitable compensation cables.

  KATALOG PARCHIMOWICZ PDF

If the selected input type is changed, the value of C. Set appears on the display. Pay attention to the polarities of the thermocouple cables as shown in the figure right are connected to the. UnIt Offset value is added to the measurement value. If self tune is achieved A. When PID parameters are Filter for display value. IfInp parameter is selected TC or Pt, this parameter is seen. All input and output lines that are not connected to the supply network must be laid out as shielded and twisted cables.

If deviation alarm is selected, A1. It’s a community-based project which helps to repair anything.

While holding 25 REdY. If this parameter is adjusted to a value closer to the energy requirements of the system at the set point, process temperature is prevented to rise or drop to dangerous levels. Etv between 1 and These cables should not be close to the power cables or components.

If 0 is selected, soft start feature will be enable and the device reaches set point value quickly. If this parameter is 1, digital filter runs most quick. The minimum value is the value of C. Read this document carefully before using this device. If band alarm is selected, A1. Press any key to deactivate the ejda procedure.

  CIRCUITOS ELECTRICOS NILSSON RIEDEL PDF

Otherwise, Self-Tune should be activated. Set point during normal operation Date value endaa programming SET Do not use the device in locations subject to corrosive and flammable gases.

Alternatively, the same function occurs first pressing Entering from the programming mode to the run mode: While cleaning the device, solvents thinner, benzine, acid etc. If no key is pressed within 20 seconds during programming mode, the data is stored automatically and the run mode is entered. The installation and electrical connections must be carried on by a qualified staff and must be according to the relevant locally applicable regulations.

Before self tune procedure, A.