Honeywell RMA On-Off Primary Burner Control: Hvac Controls: : Industrial & Scientific. Find great deals for Honeywell Rm a Rev D Burner Control RMA Shop with confidence on eBay!. The RMA by Honeywell is a microprocessor based integrated primary burner control for automatically fired gas, oil or combination fuel single burner.
|Published (Last):||26 December 2010|
|PDF File Size:||12.61 Mb|
|ePub File Size:||14.64 Mb|
|Price:||Free* [*Free Regsitration Required]|
Yes, but you will add 30 seconds to the pre-purge timing for each switch jumpered. Can I jumper terminal G to L2? Order Status and History.
Yes, but a relay will have to be added. Turn off more accessible mode.
Product Info Literature Overview Microprocessor-based integrated primary burner control for automatically fired gas, oil or combination fuel single burner applications.
If using the two-second-purge card, the airflow switch must close in 2 seconds.
RMA CONTROL W/INTERMIT PILOT V HONEYWELL RMA
The relay recognizes the wiring error and locks out. Yes, order part number General Questions Applying to all Series Q.
The RMA and C do not have this feature. This means the relay is checking itself internally. Part of the safe-start check is continuous in stand-by, and part happens every time there is a call for heat.
Second, note that the jumpers are not just wires. No 4-second is available. Please contact Customer Care for assistance. Honeywell actually tested to overcycles! No, the Power LED is supposed to blink every four seconds. Interchangeable plug-in flame amplifiers. This Info-Tec will attempt to answer some of those questions. The control will wait two minutes for this fault to clear.
RMA,RMA,Honeywell,,FSG Control Auto Primary V Primary Co,Stromquist & Company
In the real world of burner service, the needed information is seldom known. Training and Development Portal. Can a low voltage controller be used with the RM? Functions include automatic burner sequencing, flame supervision, system status indication, system or self diagnostics and troubleshooting.
This page location is: If any damage is done in trying to restore a clipped jumper, the warranty is void!
The burner will immediately shut down, and lockout will occur. The power must be within certain tolerances for the control to remain on honeyqell. Does the SA display have any control of the relay functions? Forgot User Name or Password? Please enable scripts and reload this page.
The burner will post purge. The sequence will not continue if this circuit is closed. Subbase and amplifier are required for operation. There are 50 HZ controls available. If the circuit remains closed for the two minutes, the RMB and D will lockout. Pilot Type intermittent Vibration 0.